Close MenuCARBIDE HAMMER DRILL BITS 5PC
The Milwaukee 3/16 in. SHOCKWAVE Carbide Hammer Drill Bit 5 Pack uses sharpened carbide to deliver up to 5x longer life in concrete and up to 2x faster drilling into masonry materials. Engineered with a precision ground tip, these bits deliver faster starts and less walking in concrete, brick and block. The carbide-tipped masonry drill bits' wide flute design removes dust faster, reducing heat and delivering more holes per charge. Equipped with a 1/4 in. Hex Shank, Milwaukee SHOCKWAVE Carbide Hammer Drill Bits are the ideal solution for drilling in masonry materials with both impacts and hammer drills/drivers.
Milwaukee 8 Piece Screwdriver Kit with ECX
8-piece screwdriver set with ECX
Visible ID markings allows for quick tool identification on jobsite Includes: Phillips #1 x 3 in., Phillips #2 x 4 in., Phillips #2 x 6 in., slotted 1/4 in. x 4 in., slotted 3/16 in. x 6 in., slotted 5/16 in. x 6 in., ECX #1, ECX #2
Wrench ready hex shanks
Limited lifetime warranty
Includes: screwdriver set with ECX (8-piece)
Magnetic tips
ECX bit fits most specialty screws, including screws found in electrical boxes, conduit couplers and outlets
3PC PLIERS KIT
The Milwaukee 3-piece pliers kit provides solutions for a wide range of cutting and fastening applications. The 10 in. REAM & PUNCH straight jaw pliers incorporate exposed metal handles (patent pending) and a precision pliers head for reaming pipe and punching electrical knock outs. The 8 in. Long nose pliers feature a 2 in. gripping nose for pulling wire and material through rough-in holes and other tight spaces, as well as an integrated fish tape puller. The 7 in. Diagonal cutting pliers feature iron Carbide edge hardened cutting edges for up to 2X more cuts, and a tapered nose with flush cutting blades, which cut all the way to the tip. Milwaukee pliers feature over-molded comfort grips, which will not peel under jobsite conditions. All Milwaukee pliers are forged for strength and feature rust protection for long life.
Forged design for added strength
Iron Carbide cutting edge for more cuts over the life of the pliers (8 in. diagonal pliers)
Rust resistance
Reaming head design - up to 1 in. or 2 in. (patent pending)
Comfort grips - will not peel from jobsite conditions
